Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Weston Homeowners
A broken garage spring stops your day. The door won’t lift, or it slams down hard, and suddenly the car is trapped inside. That’s when you need a real answer, not a callback tomorrow. We offer same-day garage door spring repair in Weston for exactly this situation, and our technicians have up to 15 years of experience with torsion and extension systems. We work on the brands already on your home, including Clopay, Amarr, and Wayne Dalton, so nobody is guessing at part numbers. Springs are a safety issue, not just a repair: a tired spring puts stress on the opener, the cables, and anyone standing under the door. Call (833) 847-7527 and we’ll get you back in service.
What Our Garage Door Spring Repair Service Includes
Spring work is one of the most skill-dependent jobs in this trade, which is why we handle it as its own dedicated service rather than an add-on to a general repair visit. Here’s what each part of the job covers.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on the shaft above your door, and it carries most of the door’s weight through a winding and unwinding cycle. When it snaps, the door becomes dangerously heavy and the opener alone can’t lift it safely. We replace the spring on the shaft, set the winding to match your door’s weight, and test the balance before we leave. If your door has two springs on that shaft, we’ll tell you plainly whether the second one is close behind the first, because a matched pair is usually replaced together.

Extension Spring Replacement
Extension springs run along the horizontal tracks on either side of the door and stretch as the door closes. Older Weston homes often still have them, and when one lets go it can whip toward the ceiling, which is why safety cables matter on this setup. We replace the spring, check the cable that runs through it, and confirm both sides are carrying equal load. A single stretched-out extension spring makes the door crooked and wears the rollers fast, so it’s worth fixing before the second one goes.

Broken Spring Repair
A broken spring announces itself with a loud bang from the garage, and afterward the door may lift a few inches and stop or refuse to move at all. We confirm which spring failed, check the cables and drums for damage the break may have caused, and replace what’s actually broken. We don’t talk you into a full hardware rebuild when one spring is the problem. What we do is show you the failed part and explain what we found.

Spring Adjustment
Sometimes the spring isn’t broken, just out of tune: the door feels heavier than it used to, drifts down on its own, or the opener strains at the top of the travel. Adjustment means resetting the tension so the door balances properly through its whole cycle. We check the balance by hand with the opener disconnected, then set the springs to match. That’s the step that takes the load off your opener and makes the door feel light again.
Safety Cable Installation
Safety cables run through the center of extension springs so that if the spring breaks, the pieces stay contained instead of flying. Plenty of older installations never had them, and it’s a small addition with a real safety payoff. We fit cables sized for your spring and door, and we check the anchor points while we’re in there. If you’re not sure whether your door has them, that’s a quick thing for us to confirm during a spring inspection.
Spring Inspection
A spring inspection is a close look at the springs, cables, drums, and center bearing to catch wear before it becomes a breakdown. We look for gaps in a torsion spring’s coil, stretched extension springs, frayed cable strands, and loose set screws. You get a clear picture of what’s fine, what’s on its way out, and what should be handled now. It’s the cheapest way to avoid a door that quits on a morning you can’t afford it.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We’re factory-familiar with Clopay and Amarr doors, which means we know how their springs, drums, and cable setups are put together and where they tend to wear out first. Clopay doors show up on a lot of Weston homes, and their spring hardware is straightforward once you’ve worked on it enough to recognize the setup at a glance. Amarr builds a solid door too, and we know which of their models run heavier panels that put extra load on the springs over time. That familiarity saves time on the diagnosis, and it means the replacement spring is matched to the door rather than guessed at.
We also service Wayne Dalton equipment, including doors that use their proprietary spring systems, which behave differently from a standard torsion setup. Knowing the difference matters, because the wrong approach to one of those systems can damage the hardware or leave the door unbalanced. Whether you have a Clopay, an Amarr, a Wayne Dalton, or any other make, we can help. Same goes for the opener side: LiftMaster, Chamberlain, Genie, Craftsman, and Raynor are all brands we work with regularly. If the spring failure has stressed your opener too, one call covers it.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sound is usually a torsion spring breaking, and it often happens while the door is at rest. After it, the door won’t lift normally, and forcing it can damage the opener or the door itself. Stop using the door and call us.
- The door feels extremely heavy when you lift it by hand. A balanced door should lift with one hand and stay put halfway up. If it feels like dead weight, the spring has lost its tension or failed. Don’t keep testing it; that’s how people get hurt.
- The door goes up a few inches and stops. This usually means the opener is trying to lift a door the spring is no longer helping with. The opener isn’t the problem, so replacing it won’t fix anything. We check the springs first.
- A visible gap in the spring coil. A torsion spring with a clear gap somewhere along its length has broken. It can look intact from a distance, so a close look from the ground is worth it. Never reach up to touch or wind a spring yourself.
- The door hangs crooked or slams shut. Uneven tension between two springs makes one side lag, and a door that drops fast at the end of its travel has lost its cushion. Both point to spring trouble that gets worse with use. Get it checked before the door stops working entirely.
Our Garage Door Spring Repair Process – Step by Step
- 1
We ask what happened and when. A few questions on the phone tell us a lot: did you hear a bang, is the door stuck open or closed, does the opener run without moving the door. That helps us arrive with the right springs and hardware for your door’s make and size, which is how same-day repair stays possible.
- 2
We inspect the whole system, not just the spring. We check both springs, the cables, the drums, the center bearing, and the rollers, then test the door’s balance with the opener disconnected. A broken spring can damage a cable or bend a track on the way out, and we’d rather find that now than after we’ve left.
- 3
We give you a written price before any work starts. You’ll see the cost of the spring replacement and anything else we found, itemized and explained. Nothing gets added later without your okay. If the second spring is worn but not broken, we’ll tell you and let you decide.
- 4
We replace the spring with the door secured. The door gets clamped and the tension released in a controlled way before we touch the spring. This is the part of the job that requires training: torsion springs store a lot of energy, and a slip can cause serious injury. We set the new spring to the door’s weight and recheck the balance by hand.
- 5
We test the door through several full cycles. Then we check the safety reverse and confirm the opener isn’t straining. You get a walkthrough of what we replaced and what to watch for, and the door should feel light and move smoothly when we’re done. Back in service, with the garage usable again.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Weston?
Garage door spring repair in Weston typically runs $180 – $340 for one spring, depending on the spring type and the door’s size and weight. That range is for a single spring. If your door has a matched pair and both are being replaced, expect roughly twice that, since the two are usually changed together. Torsion and extension springs price a little differently, and a heavy double door takes a heavier spring than a single-car door.
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Matched pair of springs | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| Garage door repair (general) | $150 – $600 |
What moves the number: the spring type, whether one or both springs are replaced, and whether the break took a cable or a drum with it. What keeps the price fair is a written estimate agreed before any work starts, so the invoice matches the quote. Our estimates are free, and we’ll tell you if a repair you asked about isn’t actually needed. For related work, our Weston Garage Door Repair Pros team handles the whole door, and if you’re comparing options, this guide to garage door spring repair covers what to expect.
Garage Door Spring Repair Near Weston – Our Service Area
We provide garage door spring repair in Weston and the surrounding communities, including Southwest Ranches, Pembroke Pines, Davie, Cooper City, Plantation, Miramar, Sunrise, Tamarac, Lauderhill, Broadview Park, and Palm Springs North. Spring failures are urgent, so we treat them that way, with same-day service and emergency availability when a door won’t close or won’t open. If you’re just outside Weston, call and we’ll confirm coverage. Homeowners in Southwest Ranches can also read about garage door spring repair for that area, and Pembroke Pines residents can find local details on garage door spring repair there.
Serving Weston, FL – Our Local Coverage Area
We serve Weston and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Weston
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. Those springs do most of the lifting, so when one fails, the door becomes too heavy for the opener and unsafe to use. The repair means installing the correct spring, setting its tension to match the door, and confirming the door balances and reverses safely. We handle both torsion and extension systems throughout Weston.
Most spring repairs take about an hour to an hour and a half once we’re on site, and many are completed the same day you call. A single torsion spring is quicker than a matched pair, and if the break damaged a cable or drum, allow a little more time. We’ll give you a realistic window when you call rather than a number that sounds good. Call (833) 847-7527 and we’ll book it in.
Spring repair in Weston typically costs $180 – $340 for one spring, and a matched pair runs about twice that because both are usually replaced together. The final price depends on the spring type, the door’s size and weight, and whether anything else was damaged when the spring broke. You’ll get a written estimate before any work starts, and the price we agree on is the price you pay. Call (833) 847-7527 for an exact quote; estimates are free.
Yes, we service Clopay and Amarr doors, along with Wayne Dalton, LiftMaster, Chamberlain, Genie, Craftsman, and Raynor equipment. That brand familiarity means we know where these systems wear and which spring matches the door, so the job doesn’t turn into trial and error. It also means we can spot opener strain caused by a failing spring before it becomes a second repair. Whatever make is on your home, we can help.
In most cases, yes. Spring repair is one of the emergencies we handle with same-day service, and we keep emergency garage door service as a standing capability for doors that won’t close at night or won’t open when you need to leave. When you call, we’ll tell you honestly what’s available and get you the soonest slot. Call (833) 847-7527 and we’ll sort out the timing.
We stand behind our work, and we’ll explain what’s covered on your spring replacement before we start. Warranty terms can differ by spring type and job, so we put them in writing with your estimate rather than leaving it vague. If something isn’t right after the repair, call us and we’ll make it right. It’s part of why a written estimate matters.
Clear the area under and around the door so we have room to work, and stop using the door once you suspect a spring has failed. If the door is stuck open, leave it and keep children and pets away from it until we arrive. Have your opener model and door make handy if you know them, though we can identify both on site. Don’t try to lift or prop the door yourself; call (833) 847-7527 and let us handle it.
Schedule Your Garage Door Spring Repair Service in Weston Today
A broken spring won’t fix itself, and using the door while it’s unbalanced only causes more damage. Call (833) 847-7527 and we’ll get a technician out for same-day garage door spring repair in Weston, with emergency availability when the door leaves you stuck. Our technicians have up to 15 years of experience and work on the brands already on your home. You’ll get a free, no-obligation estimate with the price agreed before any work starts. For opener trouble alongside the spring, our garage door opener repair service covers that too.
Written by the team at Weston Garage Door Repair Pros.